Where is the fuel pump reset switch on a Dodge Durango?

The 2005 dodge durango fuel pump reset switch is located in the passenger footwell.

1. Where is the fuel pump reset button?
2. How do I reset my fuel switch?
3. How do I reset my fuel inertia switch?
4. What does the fuel pump reset button do?
5. Where is the fuel relay switch located?
6. Where is the fuel pump control module?
7. Why am I not getting power to my fuel pump fuse?
8. How do I get my fuel pump to work?
9. How do you reset the fuel pump on a Dodge Charger?
10. How do you know if an inertia switch is tripped?
11. Is there a fuse for fuel pump?

Where is the fuel pump reset button?

The fuel pump shut-off switch is located behind an access panel on the right side of the luggage compartment. The fuel pump shut-off switch has a red reset button on top of it.

How do I reset my fuel switch?

Turn the ignition switch OFF. Ensure that there is no fuel leaking in the engine compartment, along any of the lines or at the tank. There should be no odor of fuel as well. If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.

How do I reset my fuel inertia switch?

Press down the rubber reset button on the top of the inertia switch. 3. Turn the ignition switch to position 'II', pause for a few seconds, then return the key to position '0'.

What does the fuel pump reset button do?

In the event of an accident, the "Fuel Reset Button" will turn off the fuel pump and system.

Where is the fuel relay switch located?

In most vehicles, the relay is located in the large fuse box in the engine compartment. Remove the cover and check the diagram. You'll easily locate the relay by referring to the wiring diagram.

Where is the fuel pump control module?

The module is typically installed on or very close to the fuel pump, and in the early years of the component's use, this practice led to a design fault. Manufacturers, including Ford, initially placed the module inside the vehicle immediately above the fuel pump, typically just beneath the floor pan.

Why am I not getting power to my fuel pump fuse?

If you there is no power to the fuel pump or the relay, then there may be a possible electrical issue with the vehicle. ... If there is an issue with the switch or the circuit, perhaps a wiring problem, then power to the fuel system may be cut off.

How do I get my fuel pump to work?

Maintaining the Car Engine's Heat

So, one of the best tips to start a car with a bad fuel pump is to leave your car's engine cool. When your car cools off, it allows the fuel pump to reset without the need for pressure. Also, it would be best if you neither let your car engine get too cool or get very hot.

How do you reset the fuel pump on a Dodge Charger?

You will need to remove a lower portion of the dashboard on the driver's side in order to access the inertial switch. Holding this switch down for a few moments will reset the pump.

How do you know if an inertia switch is tripped?

if it tripped,then the button will pop up and all you need to do is push it back down until it clicks/stays down. it's rare for the inertia switch to fail,but possible.

Is there a fuse for fuel pump?

Replacing Fuel Pump Fuse

Most fuel pumps will run a 15 (Blue) 20 (Yellow) or 25 (Clear) amp fuse. Using a fuse that's too small will cause the fuse to blow again. This is a normal condition as the fuse isn't rated for the higher amps of a fuel pump circuit.