Diyvehiclerepair
- How do you take a distributor off?
- How do you free up a stuck distributor?
- Which way does the distributor turn on a Chevy 350?
- Do you have to set timing when changing distributor?
- How long does it take to change a distributor?
How do you take a distributor off?
The commonest fixing is a clamp-plate and pinch-bolt assembly; the pinch bolt is the same one that is loosened when turning the distributor to set the ignition timing . Loosen the bolt or bolts holding the clamp plate to the engine. Undo the pinch bolt and carefully withdraw the distributor.
How do you free up a stuck distributor?
spray liberally where it goes in the intake with pb blaster or good penetrating oil for several days,then LIGHTLY tap ---spray some more---tap--tap--tap---spray--tap--tap--tap ---be patient and it will free up.
Which way does the distributor turn on a Chevy 350?
A: Chevy distributors rotate clockwise, so you'd want to turn the distributor counterclockwise to advance the timing. Advancing timing to aid in cold starting will only help if the timing was retarded to begin with.
Do you have to set timing when changing distributor?
We prefer to set the initial timing for most engines at 10 degrees Before Top Dead Center (BTDC). With that set, remove the cap from the distributor. ... If the rotor is not pointed close to the Number One mark, pull the distributor and re-position the rotor until it comes close.
How long does it take to change a distributor?
A distributor specifically can be time consuming to remove and correctly install, since it's dependent on perfectly aligning the distributor and adjusting ignition timing after the replacement. In general however, this type of job in a shop environment can take up to 8 hours to complete correctly.
