Diyvehiclerepair
- What is a shock sensor on a car alarm?
- How do you disarm a GE alarm system?
- Where are shock sensors located?
- Where are car alarm sensors located?
- How do you reset a door alarm sensor?
- How do I reset my Concord 4?
- How do you program a Concord 4?
What is a shock sensor on a car alarm?
Shock sensors detect hits and impacts around your car, such as the shock of someone breaking a window. Shock sensors work by detecting when an impact occurs. If someone smashes one of your car's windows, the shock sensor detects this impact and transmits an alert to the alarm's computer.
How do you disarm a GE alarm system?
The first thing you'll want to do is go to your alarm keypad. If you know the code to disarm the alarm, enter it and see if that stops the beeping sound. If you don't know the code, look for buttons labeled “clear” or “reset” and press those.
Where are shock sensors located?
The location of the shock sensor in a vehicle is also a major factor. In theory, the best location for one is the centre of the vehicle so it is not biased to one side. Yet most of the ones I have removed are tied to the steering column!
Where are car alarm sensors located?
Car Alarm Door Sensors
Door sensors are the most basic and common sensors available, and they're found in virtually every car alarm system. These sensors can be installed in the doors, trunk, and hood of a car, and they allow the control unit to sense whenever someone opens anything up to gain access to the vehicle.
How do you reset a door alarm sensor?
Press and hold the pinhole reset button using a paperclip or the included pinhole tool. The LED light will flash green. Continue holding down the pinhole reset button until the LED light turns red. Put the back cover back on the device.
How do I reset my Concord 4?
The light on the smoke detector remains lit until it is reset. Press 1, code again to reset hardwired detectors and clear alarm memory. Note: In some cases, your installer may have installed a smoke detector reset switch. If so, press and hold the switch for at least 1 second, then release it to reset smoke detectors.
How do you program a Concord 4?
To enter program mode:
Make sure you disarm the system in all partitions. 2. Press 8, 4321, 0, 0. The display shows SYSTEM PROGRAMMING.
